25
SAFETY PRECAUTIONS
PRACTICE SAFE MAINTENANCE
Understand service procedures before doing work.
Keep work area clean and dry.
Never lubricate or service the machine while it is
moving.
Keep hands, feet and clothing from power-driven
parts.
Before performing the machine maintenance:
- Park on a flat surface.
- Lower the blade to the ground.
- Operate the engine at low idle with no load for 3
minutes to cool it off.
- Move the key into position OFF to cut-off the
engine and remove it from the switch.
- Move the control safety cut-off lever into position
LOCK.
- Let the engine to cool-off.
Place a “maintenance in progress” sign (seen in the
SAFETY DECALS chapter). This sign can be located
on the cab door.
In the event maintenance operations require
operating the engine, do not leave the machine
unattended.
In the event the machine must be lifted, block with
appropriate supports the elements of the machine
during maintenance/repair operations.
Inspect certain parts periodically and repair or
replace as necessary.
Keep all parts in good condition and properly
installed.
Fix any damage immediately. Replace worn or broken
parts.
Remove any building of grease, oil, or debris.
Disconnect the ground cable (-) from the batteries
before servicing electrical systems or welding on
the machine
MANUALEQUIPOSPESADOS.COM manualequipospesados@gmail.com
To Next Page
Loading...
