31
SAFETY PRECAUTIONS
AVOID HEATING NEAR PRESSURIZED
FLUID LINES
Flammable spray can be generated by applying heat
near pressurized fluid lines, resulting in severe burns
to yourself and bystanders. Do not heat by welding,
soldering, or using a torch near pressurized fluid lined
or other flammable materials.
Pressurized lines can be accidentally cut when heat
goes beyond the immediate flame area. Install
temporary fire resistant guards to protect hoses or other
materials when engaging in welding, soldering, etc.
AVOID APPLYING HEAT TO LINES
CONTAINING FLAMMABLE FLUIDS
Do not weld or flame cut pipes or tubes that contain
flammable fluids. Clean them thoroughly with
nonflammable solvent before welding or flame cutting
them.
AVOID HIGH PRESSURE FLUIDS
Escaping fluid under pressure can penetrate the skin
causing serious injury.
Avoid this hazard by relieving pressure before
disconnecting hydraulic or other lines.
Relieve the pressure by moving the control levers
several times.
Tighten all connections before applying pressure.
Wear a shield or protection glasses to protect your eyes.
Search for leaks with a piece of cardboard; take care
to protect hands and body from high-pressure fluids.
If an accident occurs, see a doctor familiar with this
type of injury immediately
Any fluid injected into the shin must be surgically
removed within a few hours or gangrene may result.
MANUALEQUIPOSPESADOS.COM manualequipospesados@gmail.com
To Next Page
Loading...
