EasyManua.ls Logo

AMP Command Pro iii 9500 - Page 17

AMP Command Pro iii 9500
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
The fuel valve is between fuel tank and the carburetor. When
running the unit, the fuel valve is "on" . when stop the unit
,the fuel valve turn to "off". Fuel switch
Fuel switch
5.2 Try to drain all fuel and turn the fuel petcock to the
off position when the unit will sit for a long period of time
without use. This will keep the ethanol in gasoline from
ruining the carb.
5.2.1 Electric start on the unit: Operate by turning the
starting key on the control panel. Turn the key in a
clockwise direction to start location until the unit starts.
Return the key to "on" location if failed to start, wait 30
seconds and then try to restart the unit.
off: stop the unit start : start the unit on :
running the unit
5.2.2 Recoil start: Make sure the unit to the unit is in the
"on" position. Pull the re-coil handle slightly until you feel
resistance and then pull handle immediately. If failed, repeat