14
until the unit has started. Gentle let the cord back down to
avoid damaging the pull cord. Do not let the cord have
friction or the cord may wear easily.
5.2.3 Remote control start
Make sure the key is in the "on" location. Then press the
button on the remote control that reads "on". If failed,
retry after 30 seconds.
6 . OPERATION
6.1 Ambient temp: welding 14 F- 104 F
6.2 Transport and storage: -4 F- 131 F
6.3 Relative humidity: when 104 F < 50%; when 68 F, < 90%. Max
altitude equals < 3280.84 feet.
6.4 Angle of inclination: the unit must be angled less than 10
degrees of the welding supply power.
6.5 If the unit has been overloaded after connecting the plug, the
CB will close itself on the control panel. If this is
true pleased check the other equipment is running properly.
Second check if it is overloaded.
Special Warning
1 . The CB is not in control of the power of the welder.
To Next Page
Loading...