15
2. Do not use the welder and air compressor at the same
time or generator and welder at the same time for best
performance.
6.6 Welding rods and welding leads chart: For your
reference below these are the rods and cables we see the
best performance in the AMP Triad 3 in 1 .
7 ENGINE SHUT DOWN
7.1 Remove all connections this includes generator, welding
leads and air compressor outputs. Then turn off the circuit
breaker. If the air compressor was in use
empty compressor tank of all remaining air. If welding please
remove rod connections. Let the unit run for 2-3 minutes,
then turn the key on the control panel to the "off" position.
To Next Page
Loading...