• NOTE: If using this battery charger/maintainer for a marine
battery, the battery must be removed and charged on shore
unless you have purchased special equipment designed for
marine use to allow for onboard charging.
• Check the polarity of the battery posts. Note: The positive (+)
post is usually larger in diameter than the negative (-) post.
• The length of the cord external to the battery charger and
including the attachment plug shall not be less than 6 feet (1.8m)
as measured from the face of the attachment plug to the point of
attachment or entry.
• Connect the red positive (+) charger clip to the positive (+)
battery post.
• Place the free end of the battery cable as far away from the
battery to be charged as the cable will allow and then connect
the black negative (-) charger clip to the free end of the cable.
NEVER face the battery when making the connection.
• When disconnecting the charger/maintainer, always use the
reverse order from the connection process, staying as far away
as possible from the battery.
AC POWER CORD/PLUG CONNECTIONS AND
PROPER GROUNDING
• This battery maintainer is designed for use on a 120V circuit.
Always plug the AC power cord/plug into a properly grounded
outlet that follows all local ordinances.
• NEVER change or alter the AC power cord or plug pins.
7
To Next Page
Loading...
