Ampeg BA115HP User Manual

BA115HP/BA210 Bassamp Cube
3
IMPORTANT SAFEGUARDS AND PRECAUTIONS:
All Ampeg products are designed for continuous safe operation, as long as common sense
is used and steps are taken to help avoid certain problems. Abiding by the following rules
can help prevent damage to your amplifier, yourself and others.
• The amplifier is equipped with a three-pronged AC power cord. To reduce the risk of
electrical shock, NEVER remove or otherwise attempt to defeat the ground pin of the
power cord.
• Connect the amplifier ONLY to a properly grounded AC outlet of the proper voltage
for your amp.
• Avoid sudden temperature extremes, rain and moisture. Also, avoid sudden and
intense impact. (If the unit has been subjected to any of the preceding abuses, have
it looked at by an authorized service center.)
• NEVER set the amplifier on a support that might give out under its weight.
• Always keep the total speaker impedance at or above the rated load.
• Unplug the amplifier before cleaning it. NEVER spray liquid cleaners onto the ampli-
fier. Wipe it with a slightly dampened, lint-free cloth to remove dirt and film.
• Do not use the amplifier if it has sustained damage to the chassis, controls, or power
cord. Refer the unit to an authorized service center for inspection.
• Amplifiers capable of producing high volume levels are also capable of inflicting per-
manent hearing loss or damage, if the exposure to such levels is prolonged. Such
damage is progressive and irreversible!
Declaration Of Conformity
#29, Effective 01-01-2001
Manufacturer’s Name: SLM Electronics
Production Facility: 11880 Borman Drive, St. Louis, MO 63146, USA
Production Facility: 700 Hwy 202 W, Yellville, AR 72687, USA
Shipping Facility: 1400 Ferguson Ave., St. Louis, MO 63133, USA
Office Facility: 1400 Ferguson Ave., St. Louis, MO 63133, USA
Product Type: Audio Amplifier
Complies with Standards:
LVD: 92/31/EEC, 93/68/EEC, & 73/23/EWG
Safety: EN60065
EMC: EN55013, EN55020, EN55022, EN61000-3-2,
& EN61000-3-3
Supplementary information provided by your local Sales & Services Office or:
SLM Electronics - R & D Engineering
1901 Congressional Drive, St Louis, MO 63146, USA
Tel.: 314-569-0141, Fax: 314-569-0175

Ampeg BA115HP Specifications