10
Classic Analog Bass Preamp
CLASSIC ANALOG BASS PREAMP TECHNICAL SPECIFICATIONS
Signal to Noise Ratio 75 dB
(50 Hz @ 300 mV RMS)
Maximum Gain +18 dB
Tone Controls Bass: +7/–20 dB @ 40 Hz
Mid: +5/–11 dB @ 500 Hz
Treble: +10/–10 dB @ 4 kHz
Ultra Hi: +7 dB @ 8 kHz
Ultra Lo: +2 dB @ 40 Hz / –10 dB @ 500 Hz
Impedances Input: 1 M
@ NORMAL, 83 k w/–15 dB PAD
Output: 120
Power Requirements Internal: 9 V Battery
External: 9 VDC, ≥20 mA
Size (H x W x D) 2.2 in x 2.6 in x 4.5 in
56 mm x 66 mm x 114 mm
Weight 0.6 lb / 0.3 kg (approximately)
Service Information
I
f you are having a problem with your Classic Analog Bass Preamp, you can go to our
website (www.ampeg.com)
and click on Support for service information, or call Technical
Support at 1-800-898-3211
Monday-Friday during
normal business hours, Pacific Time
,
to receive assistance. If you are outside of the U.S., contact your local distributor for
technical support and service.
The Classic Analog Bass Preamp is housed in a corrosion resistant die-cast zinc chassis, so be sure
to clean it with a dry lint-free cloth. Never spray cleaning agents on the Classic Analog Bass Preamp.
Avoid abrasive cleansers which would damage the finish.
Ampeg continually develops new products and improves upon existing ones. For this reason, the specifications
and information in this manual are subject to change without notice.
“Ampeg” is a registered trademark of LOUD Technologies Inc. All other brand names mentioned are trademarks
or registered trademarks of their respective holders and are hereby acknowledged.
www.ampeg.com
©2016 LOUD Technologies Inc.
16220 Wood-Red Road NE • Woodinville, WA 98072
Part No. SW1193 Rev. A 12/16
To Next Page
Loading...
