Ampeg Liquifier User Manual

PB
1. Input: Connect a passive or active instrument to this
Input jack.
2. Output: Feeds the signal to an external power amplifier,
mixer, or recording setup.
3. On/Off Switch: Turns the pedal on/off. The LED
indicates on/off status.
4. Rate: Adjusts the speed of the low-frequency oscillator
(LFO).
5. Depth: Adjusts the amplitude / intensity of the rate.
6. Effect Level: Adjusts the overall effect level.
7. Rate Indication LED: This LED flashes to indicate the
current rate.
8. Power: Input socket for optional AC/DC power supply.
9. Battery (not included): Provides 9V of power
(accessible by removing the four screws on the bottom
panel).
Front, Rear, Side and Bottom Panel Descriptions
1. Read and understand the included “Important Safety
Instructions.”
2. Make all initial connections with the power switches OFF
on all equipment. Make sure the Master Volume, Level and
Gain controls are all the way down.
3. Insert 9V battery or connect optional AC/DC power
supply. The Liquifier Analog Chorus may accept the
appropriate voltage as indicated on the rear panel.
4. Connect an instrument to the Input jack with a 1/4"
(shielded) instrument cable.
5. While playing the instrument, adjust the Rate, Depth and
Effect Level knobs to taste.
Getting Started

Ampeg Liquifier Specifications

Power

internal power requirements	9V Battery
external power requirements	9V DC, ≥60mA

Audio Specifications

signal-to-noise ratio	82 dB
maximum gain	+0 dB (Unity)

Weight and Dimensions

weight	0.6 lb / 0.3 kg
size	2.2 x 2.6 x 4.5 in / 56 x 66 x 114 mm