Do you have a question about the AMS SEDONA and is the answer not in the manual?
Brand | AMS |
---|---|
Model | SEDONA |
Category | Outdoor Fireplace |
Language | English |
Procedure to follow if gas odor is detected.
Avoid indoor use, never leave unattended, alert to hot surfaces.
Do not store flammable vapors and liquids near the appliance.
Properties of propane gas including flammability and odor.
Guidelines for storing and using LP gas cylinders safely.
Instructions for safely connecting the gas cylinder.
Details on the CGA No 791 connection and its flow limiting device.
Warning to protect the hose from hot surfaces to prevent danger.
Instructions for inspecting the hose and regulator seal.
Procedures for tightening connections and performing leak tests.
Instructions for correctly placing lava rocks around the burner.
Guide for installing the AAA battery for the igniter.
How to open the door and place the propane tank inside.
Instructions on securing the gas tank with the wing screw.
Procedure for connecting the gas line to the LP tank.
Procedure for safely disconnecting the gas line from the LP tank.
Ensure secure fastening of regulator valve and hose connections to burner and tank.
Step-by-step guide to perform a leak check using soap solution.
Step-by-step guide for lighting the fire table using the built-in igniter.
Instructions for lighting the fire table with an external match or lighter.
Procedure for safely turning off the fire table and gas supply.
Regular checks for safety and product life, including burner and connections.
Guidelines for cleaning exterior surfaces with mild soap or baking soda.
Specific cleaning recommendations for stainless steel components.
Instructions for safely storing the fire table when not in use.
Steps for applying a water-based sealer to the fireplace surface.
Detailed steps for cleaning the fire table and fire bowl surfaces.
Ensure pilot housing is clear and igniter pin, thermocouple are positioned correctly.
Correct positioning of igniter pin and thermocouple for proper function.
Ensuring the thermocouple wire is correctly aligned with the valve.
Common causes and solutions when the burner won't light using the igniter.
Causes and solutions for the burner failing to light with a match.
Reasons for excessive black smoke and how to resolve them.
Troubleshooting reduced flame height due to gas flow issues.
Solutions for clogged burner ports causing uneven flame.
Addressing flame blowouts caused by wind, low gas, or tripped valves.
Resolving low heat issues in cold weather due to ice buildup on tank.
Details on what the 1-year warranty covers and common exclusions.
Conditions such as proper installation and non-commercial use.
Information on typical material variations not covered by warranty.