What to do if the READY and MEDIA LEDs are blinking on my AMT Datasouth Label Maker?
If the READY and MEDIA LEDs are blinking on your AMT Datasouth Label Maker, check the media path. Also, inspect the position of the media sensor and the paper sensor. Ensure that the media is properly positioned between the Media Sensor Arms.
General| Brand | AMT Datasouth |
|---|---|
| Model | Fastmark 4000 Series |
| Category | Label Maker |
| Language | English |
Guidelines for placing and environmental requirements for printer setup.
Details the components of the printer's front panel.
Lists commands for Printer Programming Language A (PPLA).
Commands that save parameters to non-volatile memory (E2PROM).
Step-by-step guide for installing the printer driver on Windows.
Instructions on accessing and configuring printer settings via the driver properties.
Troubleshooting steps for when READY and MEDIA LEDs are blinking.
Troubleshooting steps for RIBBON OUT errors indicated by LEDs.
Detailed steps for cleaning the printer's printhead.
General technical specifications applicable to all models.
Overview of the interface specifications covered in this appendix.
Pin assignments and definition for the RS-232 serial port.
Lists and displays internal fonts available for PPLA.
Lists the 5 internal fonts available for PPLB emulation.
Step-by-step guide for connecting and using a keyboard with the printer.
To Next Page