AMYET EV900S - Pre-Ride Safety Checklist

AMYET EV900S E-bike
Ensure tires are inflated to within the recommended
limits displayed on the tire sidewalls and holding air
Ensure brake pads are correctly positioned in relation
to the rims
Ensure front and rear brakes work properly
Check brake pads for wear and ensure they are not
over-worn
Pre-Riding Safety Checklist
Ensure brake control cables are lubricated,correctly
adjusted,and display no obvious wear.Ensure brake
control severs arelubricated and tightly secured to
the handlebars
Ensure all wheel spokes are tight and not broken
Ensure rims run true and have no obvious wobbles,
dents,or kinks
Ensure tires have good tread,have no bulges or
excessive wear,and are free from any other damage.
Ensure the chain is oiled,clean,and runs smoothly
Ensure the handlebar is set correctly in relation to
the forks and the direction of travel
Check axle nuts and front wheel quick release skewer
is correctly tension, fully closed,and secure position.
Ensure handlebar and stem are correctly adjusted
and tightened and allow proper steering
Extra care is required in wet. salty/otherwise
corrosive,or dusty conditions
Test brake levers are firm and that brake,motor cutoff
functions,and brake light are functioning properly
5
Notice:Before every riding,and after every 25-45 miles,we advise following the
pre-riding safety checklist in the table below.
Basic StepsSafety Check
1. Brakes
2. Wheels and Tires
3. Steering
4. Chain