AMYET
e Drive Safety
S8 E-bike
6.Still tighten the control of of motor speed after driving should be avoided in the
brake of the phenomenon.so as to avoid the motor overload and damage other
parts too much.
7.1nthe mud or as far as possible when driving on rough road with human drives.
8. Rain and snow weather,road surface wet.braking distance should be increased.
When riding,should focus on,slow carefully,prevent the side slip.
9. The default of the over-current protection device. In the uphill slope cases
such as larger,against the wind,wind speed is larger.can make the circuit
current exceeds rating(flow),the best can use pedal power,power and
influence range not not only otherwise,serious will burn out motor and
electric appliance. The bike body and electrical components shell should
not be charged,its insulation resistance value is not less than 2 MQ.
10. Controller has under-voltage protection function,when the voltage is lower
than under voltage value automatically power cut in order to protect the
service life of the battery.
Parking and matters needing attention:
1. When you get off for should shut off the power switch,in order to prevent
when push has no intention of rotation speed caused by the accident.
2. When parking should be in the flat ground up and lock parking holder and
turn the power off.
3. For your driving safety,but also make your bike can stay in the best
condition and regular maintenance and cleaning.
10
To Next Page
Loading...