AMYET
e DISPLAY AND SETTING
3.7 Setting
S8 E-bike
POI: Backlight brightness, level 1 is the darkest, level 3 is the brightest;
P02: Unit of mileage, O: KM; 1: MILE;
P03: Voltage level: 24V, 36V, 48V, default 36V;
P04: Sleep time: O, no sleep; Other numbers are sleep time, ranging from I to 60;
Unit minute;
P05: PAS:O-3 mode:
model: 2V,
mode2: 3V,
mode3:4V;
1-5 mode:
model :2V,
mode2:2.5V,
mode3:3V,
mode4:3.5V,
mode5:4V;
P06: Wheel diameter: Unit, inch; Accuracy: 0.1;
P07: Speed measuring magnetic steel number: Range: 1-100;
P08: Speed limit: O to 100km/h.100 indicates that the speed limit is not limited,
1. Non-communication state (instrument control) : When the speed is greater than
the set speed, turn off the PWM output; When the speed is lower than the set
speed, the PWM output is automatically turned on, and the driving speed is the
current speed ±1km/h; (Only for power speed limit, no speed limit on the handle).
2. Communication state (controller control) : drive speed maintained at the set value,
error: ±1km/h; (Power andhandle speed limit) Note: The value here is based on
kilometers. When the unit setting is converted from kilometers to miles, the speed
value in the display interface will be automatically converted to the correct mile
value, but the speed limit data set in this menu under the mile interface will not be
converted, which is inconsistent with the actual displayed speed limit value of miles.
P09: Zero start, non-zero start Settings, O: zero start; I: non-zero startup;
PIO: Drive mode set O: power drive (Determine how much power tooutput through the
power gear, at this time Turn handle is invalid).
1:Pure Electric (by turning the lever drive, the power mode is invalid at this time)
2: PAS mode and Pure Electric is used at the same time(Pure Electric is invalid in
zero start state)
19
To Next Page
Loading...