AMYET S8 - Page 22

AMYET
e DISPLAY AND SETTING
p II
: Assist sensitivity setting range: 1-24;
PAS setting range: 0-5;
p 13
P19:
P20:
S8 E-bike
: The type of the assisted magnetic steel plate is set in 3 types: 5,8,12 magnetic steel;
The default current limiting value of the controller ranges from 1 to 20A;
• The function is not available;
ODO Clear Setting Hold down the up key for 5 seconds to clear ODO;
O:disable cruise, I: enable cruise. Automatic cruise Optional(valid for Protocol 2 only);
Display speed ratio adjustment range: 50%—150%;
O indicates the enable bit. O: contains the O file. 1: does not contain the O file;
Protocol 0: 2 Protocol I: 5S Protocol 2: Standby 3: standby;
Key Introduction:
The specific combination positions of keys are as follows: Key
operation includes short press and long press, and combination
key long press.
Short press for quick/frequent operations, such as
1: When riding, you need to modify the power/speed gear, short click.
2: Switch the display data in the multi-function areawhile riding, tap it.e
power/speed gear, short click.
Single key long press mainly used for mode/switch state switch Compound key (long
press) Used for parameter setting, because the operation is complex, so as to reduce
misoperation (short press do not do the compound key, because it is easy to trigger
by mistake, operation is too difficult).
Specific operation explanation:
1. Modify the power mode/electric mode assume that the current
PAS mode
(1) Short Press PAS + 1
20