AMYET
e Pre-Riding Safety Checklist
S8 E-bike
Notice:Before every riding,and after every 25-45 miles,we advise following the
pre-riding safety checklist in the table below.
Safety Check
1. Brakes
2. Wheels and Tires
3. Steering
4. Chain
Basic Steps
• Ensure front and rear brakes work properly
Check brake pads for wear and ensure they are not
over-worn
• Ensure brake pads are correctly positioned in relation
to the rims
• Ensure brake control cables are lubricated,correctly
adjusted,and display no obvious wear.Ensure brake
control severs arelubricated and tightly secured to
the handlebars
• Test brake levers are firm and that brake,motor cutoff
functions,and brake light are functioning properly
Ensure tires are inflated to within the recommended
limits displayed on the tire sidewalls and holding air
• Ensure tires have good tread,have no bulges or
excessive wear,and are free from any other damage.
• Ensure rims run true and have no obvious wobbles,
dents,or kinks
Ensure all wheel spokes are tight and not broken
• Check axle nuts and front wheel quick release skewer
is correctly tension, fully closed,and secure position.
• Ensure handlebar and stem are correctly adjusted
and tightened and allow proper steering
• Ensure the handlebar is set correctly in relation to
the forks and the direction of travel
Ensure the chain is oiled,clean,and runs smoothly
• Extra care is required in wet. salty/otherwise
corrosive,or dusty conditions
5
To Next Page
Loading...