EasyManuals Logo

Analog way Picturall Quad User Manual

Analog way Picturall Quad
4 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Picturall Quad - Ref. MSQ04-R1
QUICK START GUIDE
Thank you for choosing Analog Way and the Picturall Quad. By following these simple steps, you will be
able to set up and use your Powerful media server within minutes. Discover the Picturall Quad capabilies
and intuive interface while commanding top-notch presentaons and unleash your creavity for a new
experience in show and event management.
• 1 x Picturall Quad (MSQ04-R1)
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device control)
• 1 x USB memory sck containing soware and technical documentaon
• 1 x Rackmount kit
• 1 x User manual (PDF version)*
• 1 x Quick start guide*
* User manual and quick start guide are also available on www.analogway.com

The Picturall Quad uses standard ethernet LAN
networking. To access the Web Congurator,
connect a computer to the Picturall Quad using
the Ethernet cable. Then on your computer, open
an internet browser and enter the IP address of
the Picturall Quad (displayed on the front panel
screen).
The connecon should start.
Oen, computers are set to DHCP client (automac
IP detecon) mode. You may need to change the
IP address conguraon on your computer before
you can connect. These sengs are found in the
properes for your LAN network adaptor, and vary
by operang system.
The default IP address on the Picturall Quad is
192.168.2.140 with a netmask of 255.255.255.0.
Therefore, you can assign your computer a stac
IP address of 192.168.2.100 and a netmask of
255.255.255.0 and should be able to connect.
If the connecon is not starng:
Be sure the computer IP address is on the same
network and subnet as the Picturall Quad.
Be sure that no two devices have the same IP
address (prevent IP conicts)
Check your network cable. You will need a
crossover ethernet cable if you are connecng
directly from the Picturall Quad to the computer.
If a hub or switch is involved, use straight ethernet
cables.
For more informaon, please see the user manual
or contact your local technical support.
Once succesfully connected, the Web Congurator
is displayed automacally.
CAUTION!
Mounng using only the front
rack ears is sucient for xed
installaons. Addional support,
such as the rear rack support or
slide rails, is required for mobile
applicaons, and recommended
for all.


hp://bit.ly/AW-Register
WHAT’S IN THE BOX
QUICK SETUP & OPERATION

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Analog way Picturall Quad and is the answer not in the manual?

Analog way Picturall Quad Specifications

General IconGeneral
BrandAnalog way
ModelPicturall Quad
CategoryServer
LanguageEnglish