Analogue Duo - Controller Pairing and Maintenance; Supported Controllers; Pairing Controllers to Duo; Force Disc Eject

V1.0 Dec.2023analogue.co 9 / 11
Supported Controllers – Duo OS v1.0
• Switch Pro (and variants) • 2.4g N30 • 8BitDo Pro 2 • 8BitDo N30 Pro
• Switch Joycon • 2.4g N30 (Noir) • 8BitDo Zero 2 • 8BitDo N30 Pro 2
• WiiU Pro • 2.4g SN30 • 8BitDo Lite • 8BitDo Arcade
• Wiimote • 2.4g SN30 Classic • 8BitDo Lite 2 (BT & USB only)
• Stadia • 2.4g SF30 • 8BitDo M30 • 8BitDo NeoGeo
• Xbox 360 & Xbox One • 2.4g M30 • 8BitDo SN30 • 8BitDo Micro
• PS3, PS4 & PS5 • 2.4g M30 Classic • 8BitDo SN30 Pro
• Turbo mini • 2.4g PCE • 8BitDo SN30 Pro+
• KingKong 2 Pro
Pairing controllers to Duo
1. Press the pairing button on the left side of Duo (required for 2.4g controllers) or select “Pair Controller”
from the OS menu. A Controller LED indicator will start to blink. Duo is now in Pairing mode.
2. Put your controller in pairing mode by holding the pairing button.
3. Your controller will pair to Duo. Controller LED indicator will become solid when a controller is paired
or wired controller connected to a USB port.
4. Pair additional controllers by repeating the above steps.
A 5th controller can be connected via the miniDIN or by using an original Multitap device. A controller
connected via the miniDIN will always be assigned to Player 1. Duo does not support USB hubs as well as
mixing a Multitap device with wireless or USB controllers.
8BitDo Bluetooth controllers need to be in X-Input mode before pairing.
8BitDo 2.4g controllers require specic rmware to work with Duo. This will disable compatibility with
included original and USB controller port receivers unless reverted. The rmware update can be reverted
by the same method indicated to update the rmware. Please visit support.8bitdo.com/analogue/Dock for
rmware and instructions.
Force Disc Eject
Method 1: Unplug USB power from Duo along with any connected USB devices then plug power back in.
Power on Duo while repeatedly pressing the CD eject button for 3-4 seconds to eject the disc.
Method 2: On the root of your SD card create a blank .txt le and name it “duo_eject.txt“ (case sensitive).
Unplug USB power from Duo along with any connected USB devices. Insert the SD card with the new le.
Plug in USB power and power on Duo to eject the disc automatically. If the disc does not eject on the rst
try please try again by repeating the above steps. Be sure to use the included USB-C cable and Power
Supply. Delete the newly created le from the SD card before continuing to use Duo.
Factory Resetting Duo
Resetting will restore factory settings and erase all controller pairings from the Duo. Library and Memories
will not be aected. Select and conrm “Global Reset” from OS menu Settings>Duo.
Manually Resetting Controller Pairings: Plug the USB-C power into Duo while holding the pairing button.
Wait until the Controller LEDs begin to ash green and release the pairing button before the green LEDs
turn o. If successful, all four Controller LEDs will ash red.