You need to press [0K] again to clear the fault codes, or you
can press [ESC] button to give up clearing fault codes, as
follows:
Version Information
Erase fault codes had success.
Please wait 10 seconds, Turn ignition
Off and Switch on again
Read fault codes to verify
ESC
2.2.4 Read Datastream
Choose [Read Datastream] then press [0K] button as follow:
Select Function
Version Information
Read Fault Codes
Erase Fault Codes
Read Datastream
Choose [Select Items] and press [0K] button as follows:
Select Function
View All Items
Select Items
Select Datastream
All Datastream Of Page
Engine speed[rpml
DISA potentiometer vo tage[v]
Throttle opening[%l
Throttle opening[%]
Press [LEFT] and [RIGHT] buttons to page
Press [UP] and [DOWN] buttons to select one by one
Press [0K] button to select the Datastream
Press [ESC] button to read Datastream
EN 7
To Next Page
Loading...
