Preface
Warning
1．Thanks for purchase this product, this user manual shall be carefully read before first time use of
the product.
2．Always keep this manual handy since it contains important information about using the product.
Note: Due to the fact that the ANCEL Diagnostic Smoke Leak Detector product line consists of a series of product models, which vary
from one model to another, not all of the descriptions in this manual are applicable to all product models. Please refer to the specific
product configuration for the applicability of the introduction.
Operator shall have basic knowledge about structure of vehicle and the engine.
Vehicle service book is required.
Do NOT use the product on smoke sensitive component. Eg. Smoke residual
might reduce sharpness of head lights if apply to head light housing.
Check oil level before use, if oil level is lower than the middle of the gauge, the
unit would need a refill, but do not overfill the unit beyond the gauge.
The product is only allowed to use while ignition’s off.
Be sure to use 12V vehicle battery, and the battery shall be full charged and
voltage not lower than 12V.
ONLY low density mineral oil based fluid is allowed to use as smoke
oil. Johnson&Johnson’s baby oil(pink label) is compatible. Use funnel
to avoid spread the oil to other parts of the unit.head light housing.
To ensure better test result, it’s required there’s no wind in the operating area.
Use bright light torch/ halogen light to help find the leaks.
Wear goggles if available.
To Next Page
Loading...