ANCEL VD700 - Page 8

2.1.1.3 Choose[ Erase fault codes l, then press [0K] button .
The screen displays as follows
Information
Erase fault codes!
Information
Erase fault codes had success.
Please wait 10 seconds, Turn ignition
off and Switch on again.
Read fault codes to verify.
Are you sure?
0K ESC 0K ESC
2.1.1.4 Choose[ Read Datastream], if enter number:005
screen shows as follows
Input channel Special Functions
0K
Delete
Input a channel number
1
(0-255)
2
3
4
3/ 12
2.1.1.5 Choose[ Basic setting], if enter number:005. The
. The
CH:5
ASCLL Character
ASCLL Characte
Count
Count
300
365
screen shows as follows
0K
Delete
1
2
3
4
3/12
Input channel
Input a channel number
(0-255)
0K ESC
Throttle Learning
This function is not supported
on this vehicle
Note!
When ten test function is
abnormal,Please use the
feedback function(tool setup)
0K ESC
7