Safety Precautions and Warnings
To avoid injury or damage to the vehicle and/or scan tool, first
read this manual and observe the following safety precautions
when working on a vehicle:
• First, turn off the ignition. Connect the 16-pin connector, and
then turn on the ignition.
• Always perform vehicle tests in a safe environment.
• Do not attempt to operate or observe the device while driving a
vehicle.
• Operating or observing the device distracts the driver and may
result in a fatal accident.
• Wear safety glasses that meet the standards of ANS'.
• Keep clothing, hair, hands, tools, test equipment, etc. away
from all moving or hot engine parts.
• Operate the vehicle in a well-ventilated area: exhaust fumes
are toxic.
• Place blocks in front of the drive wheels and never leave the
vehicle unattended while performing tests.
• Use extreme caution when working near the ignition coil,
distributor cap, ignition wires and spark plugs. These compo-
nents generate dangerous voltages when the engine is running.
• Keep a fire extinguisher nearby that is suitable for gasoline,
chemical, and electrical fires.
• Keep the scan tool dry, clean, and free of oil/water or grease. If
necessary, use a mild detergent on a clean cloth to clean the
outside of the scan tool.
Instructions Manual
1) Turn on the vehicle ignition;
2) Locate the vehicle's 16-pin Data Link Connector (DLC);
3) Connect the device to the vehicle's 16-pin Data Link Connec-
tor, do not use USB to power devices;
4) Start using your device.
EN
To Next Page
Loading...
