2
PARTS
CANOPY SIZE
BASE CONFIGURATION
HARD (ASPHALT)** OR VERY STIFF**
SOIL
STIFF** SOIL
10’ x 10’
12’ x 12’
THRU
20’ x 20’
20’ x 30’ 20’ x 40’ 10’ x 10’
12’ x 12’
THRU
20’ x 20’
20’ x 30’ 20’ x 40’ 10’ x 10’
12’ x 12’
THRU
20’ x 20’
20’ x 30’ 20’ x 40’
SIDE POLE 4 8 10 12 4 8 10 12 4 8 10 12
CENTER POLE 1 1 2 3 1 1 2 3 1 1 2 3
5/8” x 24” STEEL
STAKES
8
* 12* 14* 16* 8* 12* 14* 16* 8* 12*
00
1” x 30” STEEL
STAKES
00 000 0 0 000
14
* 16*
CARABINER 0 0 0 0 0 0 0 0 0 0 14 16
BAG WITH TOP 1 1 1 1 1 1 1 1 1 1 1 1
BAG FOR
POLES
11 111 1 1 11111
BAG FOR 5/8” x
24” STAKES
11 111 1 1 11100
* IMPORTANT NOTE: REFER TO CAUTION STATEMENT #2 FOR IMPORTANT WARNING ABOUT NUMBER OF STAKES SUPPLIED. (SEE BACK PAGE
OF THIS MANUAL)
THE INSTALLER MUST USE THE LOCAL SOIL CONDITIONS TO CALCULATE THE ACTUAL NUMBER OF STAKES REQUIRED AND IS RESPONSIBLE
FOR THE STAKING PATTERN AND CONFIGURATION. SEE CHART ABOVE FOR STIFF, VERY STIFF AND HARD (ASPHALT) SOIL STAKING LAYOUTS.
**THIS REPRESENTS 1 OF 6 SOIL CONDITIONS REFERENCED IN THE IFAI GUIDE: “PULLOUT CAPACITY OF TENT STAKES”. YOUR SOIL CONDITION
MAY DIFFER. THEREFORE, DIFFERENT STAKING REQUIREMENTS WILL RESULT. ANCHOR INDUSTRIES RECOMMENDS ERECTING TENTS ONLY IN
THE ABOVE-MENTIONED SOIL CONDITIONS.
ALL PURPOSE CANOPY PARTS LIST
INSPECT SITE
CAUTION:
Consult your local utility locator service or the
National Utility Locating Contractors Association
(NULCA) prior to installation.
Prior to actual tent assembly, be sure to look up,
down, above & below for obstacles, pipes, wires,
trouble, etc.
LAYOUT &
CHECK
Use parts list for a quick identifi cation and check
list for proper quantities.
MANPOWER
REQUIRED
Two installers should be able to
assemble an All Purpose Canopy in
approximately thirty minutes.
TOOLS REQUIRED
Sledge Hammer
3 PC. CENTER
POLE
2 PC. SIDE POLE
5/8” x 24” STEEL STAKE
1” x 30” STEEL STAKE
(PACKED IN CARTON)
CARABINER
BAG
WITH
TOP
BAG FOR 5/8” x 24”
STAKES ONLY
BAG WITH POLES
To Next Page
Loading...
