OPERATION
VEGETABLE/FRUIT JUICE
1. Lay the appliance on a flat horizontal surface and make sure it is unplugged and the “Speed
knob” turned to “OFF” position before operating.
2. Prepare the vegetable/fruit well. Take carrot for example. First, peel the carrot and cut it into
cubes with a size of 15mm*15mm*15mm, then remove the measuring cup and jar lid. Put the
carrot cubes into the jar. Usually certain amount of purified water has to be added to facilitate
the smooth running of appliance. The proportion of the carrot and water is 3:2 (1050g Carrot +
700g Water). The amount of mixture should not exceed the maximum level as indicated on the
jar.
NOTE: Never use hot liquids or run the appliance empty.
3. Close the jar lid and measuring cup well in position. The jar lid must be closed properly, or
the appliance cannot be activated.
4. Install the jar onto the motor unit. Make sure that the jar is installed correctly.
5. Connect the appliance with power source.
6. Turn the “Speed knob” to “ON” position, and the indicators of the four buttons will light
up. Press the “Pulse” button, and its corresponding indicator lights solidly while the indicators
of the other three buttons will be OFF, then the appliance starts to work. Alternatively, you can
turn the “Speed knob” to the speed settings ranged between “Min” and “Max” to extract juice
at your desired speed.
NOTE: The speed cannot be adjusted by the “Speed knob” when the appliance is running
under the “Pulse” mode.
NOTE: During the working process of extracting juice, if you want to stop the appliance, you
can release the “Pulse” button or turn the “Speed knob” to “OFF” position.
7. During operation, you can remove the measuring cup and add ingredients into the jar through
the center opening on the jar lid, and then replace the measuring cup.
NOTE: Do not remove the jar from the motor unit during working process. If it is necessary to
remove the jar, please firstly turn off the appliance to stop operation and then remove the jar.
To Next Page
Loading...