Replacement Guide
For Center Mullion on Andersen
®
3000 Series
Self-Storing Door with Retractable Insect Screen
READ ENTIRE GUIDE BEFORE BEGINNING INSTALLATION. Please handle your components with care to avoid damage and/or scratches.
PLEASE NOTE: Proper assembly, installation and maintenance are essential if the benefits of your Andersen
®
product are to be fully attained. Therefore,
please read and follow this guide completely. If your abilities do not match this procedure’s requirements, contact an experienced contractor.
You may direct any questions to the Solution Center at 1-800-933-3626, Monday through Friday, 7 a.m. to 7 p.m. Central Time, and Saturday
and Sunday, 8 a.m. to 5 p.m. Central Time.
IMPORTANT
wa r n i n g
Improper use of hand or power tools could result in injury and/or product damage. Follow equipment manufacturer’s instruc-
tions for safe operation. Always wear safety glasses.
RECOMMENDED TOOLS
• Safety Glasses
• Phillips head screwdriver
EMCO Enterprises, Inc.
PO Box 853
Des Moines, IA 50306-0853
Revised 01-2007 6354
Part Number 616146
EMCO Enterprises, Inc. is a wholly owned subsidiary of Andersen Corporation. EMCO manufactures Andersen® and EMCO®
doors. EMCO supports the limited warranties covering Andersen® storm and screen doors. “Andersen”, “EMCO” and all other
marks where denoted are trademarks of Andersen Corporation. ©2007 Andersen Corporation. All rights reserved.
PARTS LIST
#8 X 3/8”
PHiLLiPS FLaT
HEaD SCrEw
QTY: 2
CEnTEr muLLion
QTY: 1
1. LOWER VENTILATING WINDOW:
Lower the ventilating window a few inches so the bottom
of ventilating window is below center mullion.
A.
STEP 1
CEnTEr muLLion
inTErior ViEw
Door
FramE
boTTom oF
VEnTiLaTing
winDow
To Next Page
Need help?
General