How to care for your Accoya wood front
Wiping down the wood front with a damp cloth on a
regular basis, to remove dirt and insects, will help extend
the wood’s lifespan. With both metal & wooden fronts, we
recommend using a cotton wool bud to clean in the
grooves of the fascia, if you really want to give it some TLC!
Clean the surface with warm water and a soft cloth. Rinse
with clean water. Wipe dry with a soft cloth.
Cleaning the Andersen badge
The metal Andersen badge on the front of your charge
point can be cleaned & maintained the same way that you
would clean your metal front & sides, using a warm, damp
cloth. Please do not use any abrasive cleaner as this may
damage your unit. There is no need to remove any screws
or parts of the charge point.
Looking after the cable and connector
When not in use, ensure your cable is correctly wrapped
around and the connector is placed back in the lid at the
top of your charge point, facing downward. Please note
that the charging cable must be wound back anti-
clockwise. Ensure when you wrap the cable back into its
stored position it is disconnected from the vehicle and be
careful not to allow the cable to twist as it is wound back.
Any twisting, misuse or incorrect storage will damage the
cable, and this is not covered by Andersen warranty.
Cleaning your charge point
If you have a metal front to your A3 unit, we recommend
using a damp cloth to keep your charge point clean. This
applies to the sides of your unit also. Please do not use any
abrasive cleaner as this may damage your unit. There is no
need to remove any screws or parts of the unit.
Andersen Quick Start Guide v2.0 - Page 23
To Next Page
Loading...
