Your charge session will be stopped automatically by your
vehicle reaching its desired charge level or at the end of a
schedule. If you wish to finish charging before the session has
ended, you can do this by pressing the ‘Stop charging’ button
on the Andersen app Overview screen.
Carefully wind your cable back anti-clockwise, out of sight,
around your charge point, and place the connector securely
into its storage compartment. Make sure the connector pins
face down into the charge point.
Unplug the connector from your vehicle by holding it firmly
and pulling it towards you. If the connector doesn’t release,
make sure your vehicle is unlocked or please consult your
vehicle manual.
Close the lid to ensure the connector is protected.
Stopping a charging session
Andersen Quick Start Guide v2.0 - Page 8
Designer EV Charging
To Next Page
Loading...
