Andersen PowerAssist - Page 48

48
9068150
Command/Response byte denitions
Home Automation Programming (RS485 Connection)-Continued
55
AA
5A
A5
5C
27
B1
other
OPEN/
CLOSE/
STATUSWITHPOLL
STOP
STATUSWITHOUTPOLL
BUSY
ACK
not dened
Example to close
window 1 on console 1:
Example to get status
for all windows on
console 1:
Example to get status
for all windows on
console 1:
FF 01 01 AA AC
FF 01 05 A5 AB
FF 01 05 5C 62
Command used to open a window
or windows
Command used to close a window
or windows
Command used to request window status.
Console will request the latest window
status by querying windows over the radio
frequency (RF) communication channel.
Command used to tell the window to stop
moving. The STOP command should always
go through and should therefore never
receive a BUSY response.
Command used to request window status
without querying the windows over the
radio frequency (RF) channel. The console
will simply reply with the latest cached
status.
Reply sent by the console if it cannot
complete the command due to a previous
command that is in progress.
Reply sent by the console to commands
such as STOP, OPEN and CLOSE. E.g. when
the console gets a command to open
window 2 then the console will ACK this
command and then send the radio
frequency (RF) command to the window. It
may take up to 20 seconds for the
operation to conclude. It is the controller’s
responsibility to request status later to
conrm the correct window state has been
attained.
Command Name Usage Example Example Bytes
(hex)