EasyManua.ls Logo

Andis HS-2 - PRODUCT FEATURES; Air and Heat Settings; Cool Shot Functionality; Using Attachments

Andis HS-2
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
HIGH
MED
LOW
OFF
125
250
250volts. For connection to a 250 volt
supply, use an attachment plug adapter of
the proper configuration for the power supply
receptacle.
AIR/HEAT SETTINGS
At the 125 volt position, there are 3 air/heat
settings: LOW, MEDIUM, and HIGH (Figure C).
Note the MEDIUM and HIGH settings have
the same air flow speed, however the HIGH
uses a higher temperature setting for faster
drying. At the 250 volt position, only the
LOW setting is available.
COOL SHOT
This dryer is equipped with a cool shot button
(Figure C). To deliver the cool shot of air, press
the button on front side of handle. The cool
shot is ideal for locking in curl for longer
lasting style. Just concentrate cool air on
desired curl until set.
USING ATTACHMENTS
This dryer comes with an attachment brush, a
wide-tooth and a fine-tooth attachment comb.
To use an attachment, simply slide on and
slide off of dryer (Figure D).
CERAMIC TECHNOLOGY
This dryer uses ceramic technology to provide
healthier hair compared to standard dryers.
Ceramic technology also helps keep the heat
even and consistent, to reduce drying times
and minimize stress and damage to the hair.
A
B
C
RESET
VOLTAGE
SELECTOR
SWITCH
SLIDE OFF SLIDE ON
COOL
SHOT
BUTTON
ON/OFF AND
AIR/HEAT
SETTINGS
TEST
D

Related product manuals