Andrew James Single Induction Hob - Troubleshooting

8
Electronic control of low voltage (<160V) Make sure the appliance is connected to
the voltage indicated on the rang label.
Electronic control of excess voltage
(<270V)
Make sure the appliance is connected to
the voltage indicated on the rang label.
IGBT open or short circuit Please send back to customer service.
Overheang protecon on power mode
(>150˚C)
Eliminate the course of overheang.
Once the cooktop has cooled, the
appliance can be put into operaon.
Temperature sensor open or short
circuit
The temperature sensor underneath the
glass ceramic plate is defecve. Please
send back to customer service.
Overheang protecon on TEMP. mode
(>240˚C)
Eliminate the course of overheang.
Once the cooktop has cooled, the
appliance can be put into operaon
again.
Temperature sensor malfuncon Please send back to customer service.
LED ashing “L” then power switching
o
Test that the cookware you are using is
inducon compable. If the cookware is
compable contact customer services.
Troubleshoong