EasyManua.ls Logo

ANDTE DE260 - Page 11

Default Icon
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1) Power On: The fan starts running, and the compressor starts to run
after a delay of a few seconds.
2) Power Off: The compressor stops running immediately, and the fan
stops after a few seconds delay.
3) To prevent the machine from starting and stopping frequently, there is a
3-minute delay in the start-up interval.
Press the Power Switch to turn the dehumidifier off.
Note: To protect the compressor, the fan will continue to operate for 5
seconds after the dehumidifier has shut off. So please do not
disconnect the power cord to force the dehumidifier to stop.
Always use the power button.
1) When the ambient temperature is higher than the high temperature setting
value (default 113 / 45), the system enters high temperature protection,
prompts "HH", and the compressor stops running;
2) When the ambient temperature is lower than the low temperature setting
value (default 39 / 4), the system enters the low temperature protection,
prompts "LL", and the dehumidifier stops running;
-6-