&Tradition Bellevue AJ10 User Manual

Congratulations on your new Bellevue lamp designed
in 1929 by Arne Jacobsen. We hope you will enjoy
using this product and follow these instructions to
ensure cor rect installation. If you have any questions
or comments, please do not hesitate to contact us by
mail on:
info@andtradition.com
Bellevue AJ10
Arne Jacobsen
1929
Instructions

&Tradition Bellevue AJ10 Specifications

General

Designer	Arne Jacobsen
Light Source	LED
Height	30 cm
Cable Length	2.5 m
Voltage	220-240 V
Year	1929
Bulb Included	Yes
Dimmable	Yes
IP Rating	IP20
Frequency	50/60 Hz
Color Options	Black, White, Grey

Summary

Bellevue AJ10 Installation Steps

Step 1: Location Identification

Identify lamp location, mark center, and drill a 50mm or 20mm hole.

Step 2: Lamp Placement

Insert the lamp into the drilled hole, ensuring the cord is placed first.

Step 3: Bottom Plate Fixation

Slide the bottom plate around the bolt below the table top and above washers.

Step 4: Nut Tightening

Secure the lamp by tightening the nut counter-clockwise with a wrench.

Step 5: Bulb Installation

Install the appropriate light bulb into the lamp socket.

Step 6: Shade Angle Adjustment

Adjust the flexible swan-neck to set the desired shade angle before turning on.