AndyMark AM14U4 - Chassis Frame Assembly; Chassis Frame Construction

11
Step 2: Attach the top flange of an Inside Plate to the
top (large) flange of an End Plate (am-3920) at the 8th
hole in from the end with two 10-32 x 0.500 socket
head screws (am-1002) and two 10-32 Nylock nuts (am-
1042).
Step 4: Repeat steps 2-3 on to attach the other Inside
Plate to the End Plate.
Chassis Assembly Instructions
Step 1:
Press a FR6ZZ (am-0028) and a FR8ZZ-
HexHD (am-2986) bearing into the center holes on
each Inside Plate (am-3922). Make sure the bearing
flanges are on the same side as the bottom flange
of the Inside Plate.
Step 3:
Secure the bottom flange to the End Plate with
an additional 10-32 x 0.500 socket head screw and
10-32 Nylock nut.
NOTE: The top flange of the Inside Plate should
point toward the short side of the End Plate
NOTE: The top flange of the Inside Plate should
point toward the short side of the End Plate