AndyMark Climber in a Box - Pre-Assemble Bearing Plates; 1.5 Bearing Plate Assembly; 2.0 Bearing Plate Assembly

7 1-13-2022
Step 1: Align 2.0” tube bearing plates (am-4645) and 4
spacers (am-1600) as shown.
Pre-Assemble 2.0” Bearing Plates (2 Stage ONLY)
Step 2: Loosely add 10-32 screws (am-1024) and
nuts (am-1063) to the assembly.
Step 1: Align 1.5” tube bearing plates (am-4644) and 4
spacers (am-1599) as shown.
Pre-Assemble 1.5” Bearing Plates
Step 2: Loosely add 10-32 screws (am-1049) and
nuts (am-1063) to the assembly.
Leave hardware loose! Bearing plate assemblies will be used as drill guides for the box tubes.
Leave hardware loose! Bearing plate assemblies will be used as drill guides for the box tubes.