What to do if the Anets PASTA PRO GPC-14 Commercial Food Equipment thermostat is defective?
If the pilot is burning, the safety valve knob is 'ON', and the thermostat knob is at the highest set-point, the burners should be firing. If not, the thermostat may be defective and should be replaced.
What to do if the basket does not lower when pressing the timer button on my Anets PASTA PRO GPC-14 Commercial Food Equipment?
To resolve this issue, ensure the supply circuit breaker is 'ON' and that the unit’s power cord is properly plugged in. If the problem persists, check the wiring and tighten all connections, paying special attention to the timers, lift motors, and microswitches. If the basket still doesn't lower, try jumping the timer terminals marked 'C' (white wire) and 'NO' (right motor – blue, left motor – brown). If the motor then operates, it indicates the timer has failed and requires replacement.
Why is the water cold in my Anets Commercial Food Equipment?
If the water in your Anets Commercial Food Equipment is cold, first check that all gas cocks supplying the unit are open. Then, verify that the thermostat isn't set too low; turn the thermostat knob to a higher set-point. Also, check the incoming gas pressure and adjust the pressure regulator as needed. Make sure there is gas supply.
What to do if the basket does not raise after the timer reaches zero on my Anets PASTA PRO GPC-14?
To fix this, first check for 120V at the microswitch by metering between the 'C' terminal (white wire) and the 'NO' terminal (right motor – brown, left motor – black). If there is no power present between the terminals, the microswitch is defective and must be replaced. If power is present and the motor does not operate, the lift motor has failed and must be replaced.
What to do if the basket raises and then sinks back in Anets Commercial Food Equipment?
If the basket raises after the timer has reached zero but then sinks back into the tank of your Anets Commercial Food Equipment, the microswitch may be improperly positioned. Ensure it is positioned correctly. If the issue persists, the lift motor may have failed and needs to be replaced.
How to fix a pilot light that won't stay lit on Anets PASTA PRO GPC-14?
If the pilot light won't stay lit on your Anets Commercial Food Equipment, begin by opening all gas cocks supplying the unit. If that doesn't work, check the incoming gas pressure and adjust the pressure regulator for 3.5 inches W.C. manifold pressure for Natural Gas and 10 inches W.C. for L.P. gas, with the burners firing. Also, make sure the pilot flame is large enough to heat the thermopile by adjusting the pilot needle valve on the gas safety valve to the full open position. Clean the pilot burner, check and tighten all wires, and inspect the thermopile. If the high-limit safety has activated, jump out high limit. If pilot then lights, replace high limit. If the issue continues, the thermopile or gas safety valve may be defective and require replacement. Finally, ensure the main gas va...
General| Brand | Anets |
|---|---|
| Model | PASTA PRO GPC-14 |
| Category | Commercial Food Equipment |
| Language | English |
To Next Page