AneX AG-2095 - Page 9

8
the plug housing)

Take the plug in your hand in order to avoid the cable flicking up
during the winding process. Press down on the cable rewind button
with the foot until the cable has rewound completely onto the
cable drum, which is inside of the cyclone vacuum cleaner.

In order to place the device in its parking position, shorten the
telescopic tube to the storage mode and use the hook located
above the floor nozzle to guide it into the cyclone vacuum cleaner
nozzle holder.
The HEPA filter, mesh filter and exhaust filter.
The cyclone vacuum cleaner functions without a dust bag. The cyclone
technology directs the dusty intake air into the dust receiver tank
using air turbulence. The mesh filter, washable long-life filter (HEPA
filter) in the dust receiver tank and the exhaust filter combine to
ensure that the air is clean before it is expelled.
Attention: The device must only be used with the filter and exhaust
air filter in place.
Emptying the dust receiver tank:
The dust receiver tank is transparent, which means that you are
always able to see how full it is. You should always empty the dust
receiver tank by the time its contents reach the MAX mark.
Always unplug the appliance before emptying the dust
receiver tank!
You can now remove both the tank and the
cleaning system from their anchored
position by simply pushing the tank
releasing button and pulling out with the
crevice handle located on the dust
receiver tank. Now simply carry the dust
receiver tank to the dust bin with the
carrying handle.
Hold the dust receiver tank over your dust bin and push the interlock