7
identified by the red marking.
Turn on the cyclone vacuum cleaner by gently tipping the foot to
press down on the ON/OFF switch.
Note:
On rare occasions it is possible that a “whistling” sound may be heard
when the device is switched on. This will cease after a short period and
does not indicate the presence of fault.
Stop:
Never use the device to vacuum clay, cement, drill or plaster. These
materials will block the filter.
Varying the suction capacity:
You can use the suction capacity regulator to select individual suction
requirements. Turn the regulator in clock-wise direction in order to
increase the suction capacity, back to decrease it.
MIN: This level is ideal when vacuuming sensitive materials such
MIN-MAX: The middle level is suitable for
upholstered furniture, carpets and
MAX: This level should only be used for robust
flooring such as wood and tiles.
Secondary air valve:
The secondary air valve, which is located on the device handle, allows
you to control the suction power of the cyclone vacuum cleaner more
finely. It is recommended that the secondary air valve be opened
when cleaning curtains etc. in order to avoid
them from being drawn in to the device.
Once you have finished vacuuming turn the device
Use either the foot or the hand to press the
ON/OFF switch on the cyclone vacuum cleaner.
Remove the plug from the wall socket. (Never
pull on the cable, always apply light pressure to
To Next Page
Loading...