Why do my AngelSounds Security Sensors have an audio scream?
An audio scream from your AngelSounds Security Sensors can occur for several reasons. First, the audio volume might be too high, in which case you should turn down the volume. It could also be due to too much gel on the probe surface; try using less gel. Lastly, check if the battery is exhausted and replace it if necessary.
What to do if AngelSounds Security Sensors have weak sound output?
If your AngelSounds Security Sensors have a weak sound output, there are a few things you can check. Initially, the audio volume might be too low, so try turning up the volume. Another possibility is insufficient gel; in this case, add more gel. Also, ensure that the battery is not exhausted and replace it if needed.
How to improve low sensitivity on AngelSounds Security Sensors?
If you're experiencing low sensitivity with your AngelSounds Security Sensors, consider these points: first, the probe might be in an incorrect position, so try to locate the correct position. Second, there might be insufficient gel, so add more gel to improve contact.
Why does my AngelSounds Personal Care Products make audio scream?
An audio scream from your AngelSounds Personal Care Products device can occur for several reasons. First, the audio volume might be too high, so try turning it down. Another cause could be using too much gel on the probe surface; in this case, use less gel. Finally, check the battery level, as an exhausted battery can also cause this issue; replace the batteries if needed.
What to do if AngelSounds JPD-100S Personal Care Products has weak sound output?
If your AngelSounds Personal Care Products device has weak sound output, there are a few things you can check. The audio volume might be too low, so try turning it up. Also, make sure you're using enough gel; if not, add more. Lastly, the battery could be exhausted, so replace it to see if that resolves the issue.
How to improve low sensitivity of AngelSounds Personal Care Products?
If you're experiencing low sensitivity with your AngelSounds Personal Care Products device, consider these factors. Ensure that the probe is in the correct position. Also, insufficient gel can cause low sensitivity, so add more gel to improve contact.
Manufacturer, address, phone, fax, website details.
Purpose and intended users of the fetal Doppler device.
Features and intended applications of the fetal Doppler.
How the fetal Doppler utilizes ultrasonic waves.
Conditions or situations where the device should not be used.
Any negative side effects associated with the product's use.
Explains various hazard warnings (Danger, Warning, Caution) in the manual.
Explains symbols used in the manual and on the product.
Procedures for checking the product upon arrival.
Lists included accessories with the product.
Steps for preparing the device before operation, including battery installation.
Guidance on locating and listening to the fetal heartbeat.
Instructions on how to record and replay fetal heartbeat sounds.
General guidelines for maintaining the product's functionality.
Procedures for visually checking the product and its accessories for damage.
Recommended cleaning agents and methods for the device.
Procedures for disinfecting the unit and transducer.
Guidelines for proper disposal of used batteries.
Information on obtaining repair services for the product.
Information on RF emissions from the device.
Device's susceptibility and performance in electromagnetic environments.
Immunity testing for non-life-supporting medical devices.
Guidelines for safe distances from RF equipment.
Operating Environment| operating temperature | 0-40°C |
|---|---|
| operating humidity | 0%-85% R.H. |
| air pressure | 500 hPa to 1060 hPa |
Power| battery type | IEC 6F22 9V alkaline |
|---|
Acoustic Output| frequency | 3.3 MHz |
|---|---|
| acoustic intensity (I SPTA) | 10 mW/cm² |
| peak negative pressure | 1 MPa |
To Next Page
