To Next PageTo Next PageWhy do my AngelSounds Security Sensors have an audio scream?
An audio scream from your AngelSounds Security Sensors can occur for several reasons. First, the audio volume might be too high, in which case you should turn down the volume. It could also be due to too much gel on the probe surface; try using less gel. Lastly, check if the battery is exhausted and replace it if necessary.
What to do if AngelSounds Security Sensors have weak sound output?
If your AngelSounds Security Sensors have a weak sound output, there are a few things you can check. Initially, the audio volume might be too low, so try turning up the volume. Another possibility is insufficient gel; in this case, add more gel. Also, ensure that the battery is not exhausted and replace it if needed.
How to improve low sensitivity on AngelSounds Security Sensors?
If you're experiencing low sensitivity with your AngelSounds Security Sensors, consider these points: first, the probe might be in an incorrect position, so try to locate the correct position. Second, there might be insufficient gel, so add more gel to improve contact.
Why does my AngelSounds Personal Care Products make audio scream?
An audio scream from your AngelSounds Personal Care Products device can occur for several reasons. First, the audio volume might be too high, so try turning it down. Another cause could be using too much gel on the probe surface; in this case, use less gel. Finally, check the battery level, as an exhausted battery can also cause this issue; replace the batteries if needed.
Operating Environment| operating temperature | 0-40°C |
|---|---|
| operating humidity | 0%-85% R.H. |
| air pressure | 500 hPa to 1060 hPa |
Power| battery type | IEC 6F22 9V alkaline |
|---|
Acoustic Output| frequency | 3.3 MHz |
|---|---|
| acoustic intensity (I SPTA) | 10 mW/cm² |
| peak negative pressure | 1 MPa |
