All settings are stored in memory so that
any changes you make will apply immediately and the next
time you turn the unit on
.
Messages
A number of messages accompanied by beeps ma
y be displayed
.
Their
meanings
are as follows
:
T
here are no stored markers in memory and you are accessing the load marker menu
.
A
ll 75 marker locations are full
–
use marker delete to make more space.
The boat transponder is attempting to ga
in a position fix. It also shows the voltage of the
boat battery and includes an
“!”
after the voltage
if
the voltage is below the trigger value.
T
he transponder
on the boat
is not connected
or has gone out of radio range or is
receiving interference
from nearby
The
battery
supply
inside
the shore unit is low.
You will need to recharge the unit for 14
hours to achieve a full battery. Do not leave on charge for more than 24 hours.
There is no need to discharge the unit before recharge as the batt
eries are NMH
technology and have no ‘memory’ effect.
A
Combination of no transponder signal and shore unit low power
.
T
he transponder had a
position
fix but has lost it either because of obstruction o
f
the
transponder
antenna or
power was inte
rrupted.
Operation
To Next Page
Loading...