2 – Overview of Kit1
• 3 4 5 – 300B Hardwiring Section
• 7,8,9,10 PS board to Driver
• 11 – 6SN7 filament wires
• 12 – connect 5687 filaments in parallel
• 13 – 5687 Filament wires
• 14 – center tap for 5687 (orange/white) 400 400 taps for rectifier tube
• 15 – center taps from Mains connect to GND
• 16 – prepared ground cable from W2 on PS PCB to chassis ground
• 17- filament for 5U4G , & power supply connection to W3
• 18 – GND connections
• 19/20 - 300B DC filaments &
• 21 – Output transformer primary wiring
• 22 – Choke connection to PS PCB
• 23 – 300B Grid Connections from Driver board to 300B Hardwiring area
• 24 – Voltage Checks
• 25 – Input RCA connections to Driver Board
To Next Page
