0403
IC Statement
This device complies with RSS-216 of Industry Canada. Operation is subject to the
condition that this device does not cause harmful interference.
RSS-Gen Issue 5 March 2019
This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada’s licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
RF exposure statement:
The equipment complies with IC Radiation exposure limit set forth for uncontrolled
environment. This equipment should be installed and operated with minimum
distance 10cm between the radiator and your body.
This device complies with Industry Canada license-ICES-003. Operation is subject
to the following two conditions: (1) This device may not cause interference, and (2)
This device must accept any interference, including interference that may cause
undesired operation of the device.
This digital apparatus complies with CAN ICES-003(B)/NMB-003(B).
Le présent appareil est conforme aux CNR d' Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
This product complies with the radio interference requirements of the
European Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A2930 is in
compliance with Directives 2014/53/EU & 2011/65/EU &2001/95/EC. The
full text of the EU declaration of conformity is available at the following internet
address:
https://www.anker.com/
This symbol indicates that this product shall not be treated as
household waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic
equipment.
GB Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type A2930 is
in compliance with Radio Equipment Regulations 2017 & Electromagnetic
Compatibility Regulations 2016 and The Restriction of the Use of Certain Hazardous
Substances in Electrical and Electronic Equipment Regulations 2012. The full text of
the GB declaration of conformity is available at the following internet address:
https://www.anker.com
This device was tested for typical body-worn operations. To comply
with RF exposure requirements, a minimum separation distance of
20mm must be maintained between the user’s body and the handset,
including the antenna. Third-party belt-clips, holsters, and similar accessories
used by this device should not contain any metallic components. Body-worn
accessories that do not meet these requirements may not comply with RF exposure
requirements and should be avoided. Use only the supplied or an approved antenna.
This device is in compliance with the essential requirements and other relevant
provisions of UKCA. All essential radio test suites have been carried out.
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 20cm must be
maintained between the user’s body and the handset, including the antenna. Third-
party belt-clips, holsters, and similar accessories used by this device should not
contain any metallic components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and should be
avoided. Use only the supplied or an approved antenna.
This device in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU. All essential radio test suites have been
carried out.
To Next Page
Loading...
