7
6
Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type
A2931 is in compliance with Directives 2014/53/EU & 2011/65/EU.
The full text of the EU declaration of conformity is available at the
following internet address:
https://www.anker.com/
GB Declaration of Conformity
Hereby, Anker Innovations Limited declares that the product type
A2931 is in compliance with Radio Equipment Regulations 2017. The
full text of the UK declaration of conformity is available at the following
internet address:
https://www.anker.com/
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok,
Kowloon, Hong Kong
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich, Germany
Anker Technology (UK) Ltd
Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11
2AA, United Kingdom
This product complies with the radio interference
requirements of the European Community.
This device was tested for typical body-worn operations.
To comply with RF exposure requirements, a minimum
separation distance of 20mm must be maintained between the user’s
body and the handset, including the antenna. Third-party belt-clips,
holsters, and similar accessories used by this device should not contain
any metallic components. Body-worn accessories that do not meet
these requirements may not comply with RF exposure requirements
and should be avoided. Use only the supplied or an approved antenna.
This device is in compliance with the essential requirements and other
relevant provisions of UKCA. All essential radio test suites have been
carried out.
Specifications
This symbol indicates that this product shall not be treated
as household waste. Instead it shall be handed over to the
applicable collection point for the recycling of electrical and
electronic equipment.
Input
Output
Operating Temperature
Radiated H-Field
TX/RX Frequency Range
5V 3A 9V 2A 12 2A
5W / 7.5W / 10W
-10° C to 40° C
-7.94dBuA/m (@3m)
110-148kHz (Only for EU and UK)
To Next Page
Loading...
