anko Dual Section Spin Mop Set - User Manual

1.Screw poles 1, 2 and 3 together tightly (see Fig. A).
2.Now that the mop handle pole is assembled, tightly screw the
pole into the mop plate(see Fig.B)
3.Gently press the white back side of the microfiber mop pad onto
the mop plate(see Fig.C).The smoother mop pad is more suitable for
use on tile, the rough mop pad is more suitable for use on the wood floors.
1.Add clean water to the mop bucket (see Fig.D). Make sure the water
level does not exceed the max fill line.You can pour water in from the
two openings in the corners or open the plastic cover and add water
to the base.
2.Gently unlock the grey latch on the lower part of the mop
pole (see Fig.E).
3.Place the mop plate into the bucket.Begin plunging the mop handle
up and down at least 10 times to complete the mop pad cleaning
and drying process( see Fig.F).
4.Adjust the pole length to a comfortable height and close the grey
latch on the lower part of the mop pole before mopping(see Fig.G).
5.When emptying the dirty water, pull-out the drainage plug, or lift
the mop bucket handle and pour water(see Fig.G).
Dual Section Spin Mop Set
Mopping System Installation Guide
Mop Assembly
How to use
Fig.B Fig.C
Fig.D Fig.E
Fig.F Fig.G Fig.H
Fig.A

anko Dual Section Spin Mop Set Specifications