anko Dual Section Spin Mop Set - Page 2

1.Mop bucket will come fully assembled out of the box and
ready for use. (see Fig I).
2.To disassemble the mop buckest for cleaning, lift the inner
bucket (see Fig.J).
Attention:
(1) To assemble the bucket, press the outer bucket handle to
the side with notch, then lift the inner bucket on the outer
bucket (see Fig.J). Make sure the handles of inner and outer
bucket on the same side (see Fig.K).
(2) Make sure the arrows on the inner bucket cover and outer
bucket aligned in a straight line before spining(see Fig.L)
Fig.I Fig.J Fig.K Fig.L
Dual Section Spin Mop Set
Mopping System Installation Guide
Mop Bucket Assembly and Disassembly
Operating Tips
Cleaning Transparent Cover
Cleaning And Disinfecting Products
After washing and drying mop, flush under the
faucet to clean transparent cover(see Fig.M).
Remove the dirt or hairs from comb(see Fig.O）
Feel free to add cleaning or disinfecting products to the mop
water for an even deeper clean. We recommend using streak
and residue-free cleaners so that there is no need for rinsing.
Fig.M
1.When washing mop, better hold your hand
here (see Fig.N ).
2. When washing mop, please remember “Spin
slowly is wetting, spin fast is water removal”.
3.“Spin slowly is wetting” means to pull the
pole to the highest level and press the pole
with power.
After waiting 1-2 seconds, operate like just
now . For the best result, please repeat the
above operation 8 times.
4.“Spin fast is water removal” means to pull
the pole to half level and press the pole with
power and fast. For the best result, plese
repeat the above opertation 6 times.
Fig.N
Before After
Clean Water
Dirty Water