ASSEMBLY INSTRUCTION INSTRUCTIONS
Unpack your heater and find the wheel-holding plate and butterfly nuts.
1.
Make sure the heater is unplugged and in the "OFF" position.
2.
TURN THE HEATER UPSIDE DOWN.
3.
Attach the wheel-holding plates onto the heater as shown in the figure. The U-plate
is fixed between the last row of fins and the other one is fixed under the metal
control chamber. Fix the castors to the vertical axis of both the wheel holding plates.
4.
Insert the butterfly nuts and tighten them securely.
5.
TURN THE HEATER UPRIGHT.
Allow the oil in the heater to settle at the bottom for 5 minutes
and the heater is now ready to use.
WARNING: Risk of fire. Do not operate the heater without wheel assemblies
attached. Operate the heater in upright position only (wheels at bottom,
controls on top). Any other position could create a hazardous situation.
Ensure that the surface beneath the heater is clean and free of any
obstructions.