Need help?Do you have a question about the anko KJ050GE-B1E2 and is the answer not in the manual?
General| Model Number | KJ050GE-B1E2 |
|---|---|
| Type | Air Cleaner |
| Filter Type | HEPA |
| CADR (Clean Air Delivery Rate) | 50 m³/h |
| Noise Level | 30 dB |
| Coverage Area | 20 m² |
Allow selection for desired speed setting: low, medium and high. Default setting at low speed.
In auto mode, the speed of the fan speed will change automatically depending on the air quality as detected by the dust sensor.
In sleep mode, the unit operates quietly at low speed. The on/off indicator is dimmed and all other indicators are off.
The air purifier has a built-in air quality sensor to detect changes to air quality in the surrounding area. Indicator will change colours according to the quality of the surrounding air.
To select speed, press FAN SPEED button repeatedly until the desired fan speed is illuminated on the control panel. Fan speed will cycle from Low, Med and High.
Auto mode and Sleep mode utilise the same button. Pressing AUTO/SLEEP button will cycle through these two settings.
To set automatic off timer, press TIMER button until timer display is on desired time 2/ 4/ 6/ 8 Hr. Unit will automatically switch off once selected time duration has lapsed.
Press and hold the AUTO/SLEEP button for 3 seconds to activate child lock function. The Child Lock indicator will illuminate. When the child lock is on, all the other buttons are not responsive. Press and hold the AUTO/SLEEP button for 3 seconds again to deactivate the child lock.
Turn off and unplug the unit. Use a soft cloth slightly dampened with a little water and dishwashing soap to wipe the outer surfaces.
Turn off and unplug the unit. Release the air inlet grille by pressing on the locking latch then pull. Grasp the left and right side of HEPA filter frame and gently pull out the filter.
To Next Page
