CAUTION: Do not operate the kettle on an inclined plane. Do
not operate the kettle unless the element is fully immersed. Do
not move when the kettle is switched on.
CAUTION: To prevent damage to the appliance do not use alkaline
cleaning agents when cleaning, use a soft cloth and a mild deter-
gent.
Before first use
Before first use, it is recommended to operate the kettle for 2 or 3
times following the instructions above, this will remove any dust or
residues remaining from the manufacturing process.
· Take up the jug kettle from the base before filling.
· To fill the jug kettle, open the cover by pulling the lid inwards, then
fill to the desired level (min 0.5L-Max.1.7L), close the lid by pressing
it down until it clicks into place.
· Plug the power supply cord into the main, press the Switch-Button
upwards, the power indicator lights up.
· When the water has boiled the kettle will automatically switch itself
off, you can stop the boiling process at any time by lifting the
Switch-Button. The power indicator will go out.
Note: Do not open the lid when steam is coming out of the spout.
Kettle is only to be used with the stand provided.
Cleaning
· First read the instructions in the section titled “Importance”.
· Avoid using abrasive cleaning agents.
· Empty the kettle and allow to cool, open the lid lift out the filter,
rinse the filter under warm water and brush off any impurities.
· Refitting is the reverse of removal.
Descaling
· Half fill the kettle with tap water and add the juice of 1 lemon to the
water.
· Boil this mixture and allow it to stand for 15 minutes. Re-boil the
mixture and allow it to stand a further 15 minutes. Re-boil this mix-
ture a third time then rinse the kettle well.
Storge
Disconnect the kettle from mains power outlet and make sure no
any water inside of the kettle body. Store the kettle in a cool dry
place along with the user manual for future reference.
To Next Page
Loading...
