anko YLW6336 User Manual (English)

Questions and Answers:

J
joshua79Aug 7, 2025
What to do if the anko Ultrasonic Jewelry Cleaner is not spraying water?
- S
  Susan ThompsonAug 7, 2025
  If your anko Ultrasonic Jewelry Cleaner isn't spraying water, there might be a few reasons. First, ensure the power point is supplying power and check your circuit breakers. Also, make sure the clean water tank has enough water or cleaning solution. The water jet hole could be blocked, so try cleaning it. Finally, ensure you are squeezing the trigger in the handle to activate the water release.
Z
Zachary HernandezAug 13, 2025
Why is the suction not strong or stopped on my anko YLW6336 Ultrasonic Jewelry Cleaner?
- S
  Suzanne Huber PhDAug 13, 2025
  If the suction on your anko Ultrasonic Jewelry Cleaner is weak or has stopped, try cleaning the small filters and emptying and cleaning the dirty water tank. Also, check for any blockages and unblock them.
J
Jeffrey BooneAug 19, 2025
What to do if my anko YLW6336 is overheating and stopping?
- A
  ashleywareAug 19, 2025
  If your anko Ultrasonic Jewelry Cleaner is overheating and stopping, clean the small filters, empty and clean the dirty water tank, and check for blockages. After doing this, allow the unit to cool down for about an hour before attempting to restart it.
S
Steven HowardAug 25, 2025
How to fix an excessively noisy anko Ultrasonic Jewelry Cleaner?
- M
  Michael BensonAug 26, 2025
  If your anko Ultrasonic Jewelry Cleaner is operating too loudly, you can try a few things. Clean the small filters and empty and clean the Dirty Water Tank. Also, check for any partial blockages and remove them. If the Dirty Water Tank is full, empty it.
R
Roy HintonAug 31, 2025
How to prevent static shock when dry vacuuming with anko YLW6336 Ultrasonic Jewelry Cleaner?
- M
  Mark WilliamsAug 31, 2025
  To prevent static shock while dry vacuuming with the anko Ultrasonic Jewelry Cleaner, try wearing insulating footwear like rubber or leather-soled shoes. You can also increase the humidity or heat level in the room, or both.

anko YLW6336 Specifications

General

Model Number	YLW6336
Category	Ultrasonic Jewelry Cleaner
Brand	anko
Tank Capacity	600ml
Ultrasonic Frequency	42kHz
Power Source	AC
Power Consumption	50W
Timer Settings	90, 180, 280, 380, 480 seconds
Power Supply	AC 220-240V, 50Hz
Material	Stainless Steel Tank
Weight	0.8kg