ANNIN ROBOTICS AR3 - Page 38

Arduino Mount:
This component must be
printed on your 3D printer
using the print file:
“Arduino Mount.STL” which
can be found at:
https://www.anninrobotics.c
om/downloads
Under the AR3 print files.
Printer settings used for
ABS:
3 layer wall thickness
20% infill
220°C nozzle
(print setting not critical for
this part)
Relay Mount:
This component must be
printed on your 3D printer
using the print file: “8
channel relay mount.STL”
which can be found at:
https://www.anninrobotics.c
om/downloads
Under the AR3 print files.
Printer settings used for
ABS:
3 layer wall thickness
20% infill
220°C nozzle
(print setting not critical for
this part)